RADIATOR AS 2012670 - Caterpillar

2012670 RADIATOR AS Caterpillar parts D5N, D6N

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2012670
201-2670
2012670

Weight: 27 pounds 12 kg.

Information:

CORE DEPTH 144 mm

CORE WIDTH 119 mm

FIN HEIGHT 0 mm

FINS PER 25.4 MM 9

MODULE HEIGHT 867 mm

NUMBER OF ROWS 6

NUMBER OF TUBES 60

Buy RADIATOR AS 2012670 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK-TYPE TRACTOR,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

All States Radiator Core fits Caterpillar D6H D6N 201-2670

$866.94

16 Aug 2025
0.0[0.00] pounds
US: Parts ASAP

All States Radiator Core fits Caterpillar D6H D6N 201-2670
All States Compatible with Caterpillar Crawler Dozer(s) D6H, D6N || Replaces Caterpillar OEM Number(s) 201-2670 || Core Type: "R" Series Core || Core Length: 32-1/4" || Overall Length: 34"

$864.95

26 Jun 2025
0.0[0.00] pounds
US: Parts ASAP

$865.94

14 Apr 2025
0.0[0.00] pounds
US: Parts ASAP

This part in 1 request: Show. This information for suppliers only!

#688677 2012670

2021-07-22

For full view, you need register

Compatible equipment models: 2012670:

TRACK-TYPE TRACTOR D5N D6N Caterpillar

Information:

(1) Width of groove for ring in thrower ... .2515 .0005 in.(6.388 0.013 mm) Maximum permissible runout (axial eccentricity) of face of ring groove ... .002 in.(0.05 mm)Clearance between ring and side of groove ... .0025 to .0045 in.(0.064 to 0.114 mm)Put engine oil on ring and install ring with word "OUT" away from crankshaft.(2) Before installation do not heat thrower higher than maximum temperature of ... 300°F(149°C)(3) Before installation do not heat gear higher than maximum temperature of ... 300°F(149°C)(4) Wear sleeves and seals: Remove wear sleeves with 5P7318 Distorter Group.Install front and rear wear sleeves and seals as follows:a. Clean the inner surface of the sleeve and the outer surface of the crankshaft with 8M8060 Quick Cure Primer.b. Put 9S3265 Retaining Compound on the cleaned surfaces.c. Install the sleeve and seal at the same time on the crankshaft as shown. See Special Instruction Form SMHS7100 for the necessary tools and complete procedure for installation of wear sleeves and seals.(5) Plug and retainer. (Earlier) Minimum torque for six plugs (later) ... 17 lb.ft.(23 N m)"Stake" (make a mark with a punch) the crankshaft to hold the plug tight.(6) Maximum length of pin out of crankshaft face ... 3.44 in.(87.4 mm)(7) Make reference to MAIN BEARINGS.(8) Make reference to CONNECTING ROD BEARINGS.(9) End play for crankshaft ... .010 to .025 in.(0.25 to 0.64 mm)