RADIATOR GP 2546017 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
ZZ 6V-9510 Face Seal Plug 1
6V-9831 Cap As 1
6V-9512 Face Seal Plug 1
6V-9833 Cap As 1
6V-9511 Face Seal Plug 1
6V-9832 Cap As 1 Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release". Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN THE PHOTOGRAPHS IN THE REMOVAL AND IN THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.Note: Put identification marks on all hose assemblies for installation purposes. Plug all hose assemblies and cap all fittings. This helps prevent fluid loss, and this helps keep contaminants out of the hydraulic system.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Open the right, rear door.
Illustration 1 g00945486
Disconnect hose assemblies (1). Position hose assemblies (1) out of the way.
Illustration 2 g00945487
Disconnect hose assemblies (2). Remove bolts (3) and remove blade pump (4).
Illustration 3 g00945497Note: Note the orientation of the coupler for installation purposes.
Remove O-ring seal (5). Remove spacer (6) and coupler (7).
Illustration 4 g00945499
Remove O-ring seal (8).