RADIATOR GP 2984927 - Caterpillar

Table 1
Required Tools    
Part Number    Description    Qty    
6V-9511     Face seal plug     1    
6V-9746     O-Ring seal     1    
    Remote drain hose with an inside diameter of
30 mm (1.2 inch)     1    
    Container for measuring     1    
FT2542     Track block assembly     1    
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Stop the engine.
Release the pressure in the hydraulic system. Refer to Testing and Adjusting, "Hydraulic System Pressure - Release".
Illustration 1 g00711138
(1) Sprocket (2) FT2542 Track Block Assembly
Place track block assembly (2) in sprocket (1) in order to block forward left travel.
Illustration 2 g00711127
(3) 6V-9511 Face seal plug (4) 6V-9746 O-Ring seal (5) Case drain hose (6) Elbow (7) Remote drain hose (8) Container for measuring
Disconnect case drain hose (5) from elbow (6). Install 6V-9511 Face seal plug and 6V-9746 O-Ring seal in the open end of case drain hose (5) .
Connect one end of remote drain hose (7) to elbow (6). Place the other end of remote drain hose into container (8) in order to measure the case drain oil.
Start the engine.
Illustration 3 g00726210
(C) Display for Digging Mode (D) Key for Digging Mode
Place the machine controls at the following settings: Engine speed dial "10", AEC switch OFF, Digging Mode and Gain/Response 2 (normal). Refer to Testing and Adjusting, "Engine Performance Test" for engine rpm settings.
Place the hydraulic activation control lever in the UNLOCKED position.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Operate full travel control for one minute.
Measure the amount of case drain oil.
Remove track block assembly (2) from sprocket (1) .
Move the travel control lever in order to reposition the travel motor.
Place track block assembly (2) in sprocket (1) in order to block forward left travel.
Repeat Steps 10 through 14 in order to obtain three measurements of case drain oil.The following values specify the maximum acceptable flow of case drain oil when the signal relief setting is 35000 490 kPa (5075 72 psi) and the travel crossover relief valves are set at 39200 1470 kPa (5700 215 psi). New travel motor ... 30 L/min (8 US gpm) Rebuilt travel motor ... 34.5 L/min (9 US gpm)