RADIATOR AS 3268640 - Caterpillar

Technical Assistance
Contact the technical communicator at your dealership if you are unable to find information in this manual. The technical communicator may contact Caterpillar for a consultation.Warnings
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Caterpillar dealer for replacement manuals. Proper care is your responsibility.
This warning label is located on the electric masts. The warning label is placed to the rear of the masts at eye level.
Illustration 1 g01069921
Warning decal that is located on the electric masts
To prevent possible personal injury during installation and removal of the laser receivers, lower the mast to the minimum height and use an approved access system to reach the mounting locations of the laser receivers at the top of the mast. Do not climb on the blade.
Note: These warnings apply when the display has been removed from an excavator and placed on a machine that incorporates automatic modes.
Unexpected blade movement may occur when the blade control system is in automatic mode. Unexpected blade movements that occur while mounting or dismounting the machine may result in injury or death. Before dismounting the machine, always place the automatic blade control system into manual mode and follow the machine parking procedures specified in the machine Operation Manual.
Once the system is placed in automatic mode, blade movement may occur. Blade movement may exceed 21 cm (8 inches). Injury or death from crushing could occur. Ensure that all personnel are clear of the blade before you place the system in automatic mode.
This warning label is located on the tripod. The label is placed in a location on each leg of the tripod in order to be easily seen.
Illustration 2 g01073304
Warning decal that is located on the legs of the laser transmitter
Movement of the transmitter could cause unexpected blade movement. Death or serious injury could occur. Turn off the transmitter before you move the transmitter or before you adjust the transmitter.
Illustration 3 g01126902
Typical Illustration of an approved access system