RADIATOR & HYD OIL COOLER GP 4335160 - Caterpillar

4335160 RADIATOR & HYD OIL COOLER GP Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4335160
433-5160
4335160

Caterpillar 4335160 RADIATOR & HYD OIL COOLER GP

Weight: 315 pounds 142 kg.

Buy RADIATOR & HYD OIL COOLER GP 4335160 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Yankee - 433-.5160 - Chucking Reamer, High Speed Steel, Bright (Uncoated), Straight, Decimal Inch, 33/64 in

$119.95

05 Jan 2024

US: Neobits_

Yankee - 433-.5160 - Chucking Reamer, High Speed Steel, Bright (Uncoated), Straight, Decimal Inch, 33/64 in
Yankee Candle These high-speed steel chucking reamers come in sizes that fall between standard trade sizes, and

Number on catalog scheme: 13

Caterpillar 4335160 Parts scheme RADIATOR & HYD OIL COOLER GP

For full view, you need register

Information:

If it is necessary to remove broken glass, use thick gloves to prevent injury.
1. Put tool (A) in between the two lips of seal (1) as shown. Move tool (A) along the seal to pull the locking lip of the seal out away from the cab. Move the tool completely around the circumference of the window assembly. 2. Remove the glass from the cab. Remove seal (2) from the edge of the window opening.Install Cab Window Glass
1. Start along the side of the window panel opening to install seal (1). 2. Install edge (3) of seal over panel (2) with the locking lip toward the outside of the cab.3. Install the seal around the circumference of the window opening. Cut the seal to extend past the starting point by .125 in. (3.18 mm) per foot of window opening circumference. Push the ends of the seal together and push them over the body panel to make a tight, smooth joint. When the window assembly is installed, edge (5) must be over window assembly (4) as shown.
Handle glass carefully.
4. Put the bottom of window assembly (6) in the channel of the seal as far as possible. Do not use too much force.5. Move in both directions from the starting point and lift the glass channel of the seal so the window assembly can slip into position. 6. Put a solution of soap and water on locking lip (7) of the seal. 7. Install the curved end of tool (A) between the locking lip and groove (8) at any point away from the joint. Move tool (A) along groove (8) as shown until the locking lip is in its correct position around the circumference of the window assembly.