RADIATOR GP 4390118 - Caterpillar

Illustration 1 g00298498
(A) Extension test (B) Retraction test
Place the machine on level ground.
The bucket should be empty.
Fully retract the bucket cylinder and the stick cylinder.
Position the bucket on the ground. With a stopwatch, measure the time that is required to fully extend the boom cylinders.
Position the boom cylinders at full extension. With a stopwatch, measure the time that is required for the bucket to come in contact with the ground.
Refer to the specifications in Table 1 for the operating speed of the boom cylinders.
Perform the following steps in order to test the operating speed of the stick cylinder.
Illustration 2 g00298558
(A) Extension test (B) Retraction test
Place the machine on level ground.
The bucket should be empty.
Position the upper surface of the boom parallel to the ground.
Fully extend the bucket cylinder.
Retract the stick cylinder. With a stopwatch, measure the time that is required to fully extend the stick cylinder.
Extend the stick cylinder. With a stopwatch, measure the time that is required to fully retract the stick cylinder.
Refer to the specifications in Table 1 for the operating speed of the stick cylinder.
Perform the following steps in order to test the operating speed of the bucket cylinder.
Illustration 3 g00298598
(A) Extension test (B) Retraction test
Place the machine on level ground.
The bucket should be empty.
Position the upper surface of the boom parallel to the ground.
Position the stick so that the stick is perpendicular to the ground.
Fully retract the bucket cylinder.
With a stopwatch, measure the time that is required to fully extend the bucket cylinder.
Position the bucket cylinder at full extension. With a stopwatch, measure the time that is required to fully retract the bucket cylinder.
Refer to the specifications in Table 1 for the operating speed of the bucket cylinder.
Perform the following steps in order to test the operating speed of the power offset boom cylinder.
Illustration 4 g01867434
(A) Extension test (B) Retraction test
Place the machine on level ground.
The bucket should be empty.
Position the upper surface of the boom parallel to the ground.
Position the stick so that the stick is perpendicular to the ground.
Fully extend the bucket cylinder.
Position the power offset boom cylinder at full retraction. With a stopwatch, measure the time that is required to fully extend the power offset boom cylinder.
Position the power offset boom cylinder at full extension. With a stopwatch, measure the time that is required to fully retract the power offset boom cylinder.
Refer to the specifications in Table 1 for the operating speed of the power offset boom cylinder.
Table 1
Cylinder Operating Speed (seconds)    
Item    New    Rebuild    Service Limit    
Boom     Extension     3.6 0.5     4.7 (1)     5.4 (1)    
Retraction 3.1 0.5     4.0 (1)     4.7 (1)    
Stick     Extension     2.5 0.5     3.3 (1)     3.8 (1)    
Retraction 2.3 0.5     3.0 (1)     3.5 (1)    
Bucket     Extension     3.5 0.5     4.6 (1)     5.3 (1)    
Retraction 2.1 0.5     2.7 (1)     3.2 (1)    
Power Offset Boom     Extension     3.3