RADIATOR GP 5073592 - Caterpillar

Conventional Cylinder
(S/N: SHA1-Up; CBD1-Up; HLS1-Up; KMW1-Up; HBE1-Up; SNL1-Up; DDT1-Up; EAT1-Up; LBE1-Up; GKZ1-Up)
Illustration 7 g01249308
Tooling (C) and Tooling (D) is used for the removal of bearing (1). Tooling (C) and Tooling (E) is used for the removal of bearing (3) . (2) Torque for the head ... 600 130 N m (442 95 lb ft) (4) Torque for the nut ... 2700 270 N m (1990 200 lb ft)Lubricate the sealing lips (5) with the fluid that is being sealed.Apply Tooling (F) to the wiper seal groove (6) prior to assembly.FSH1-Up
Illustration 8 g01249341
Tooling (C) and Tooling (D) is used for the removal of bearing (3). Tooling (C) and Tooling (E) is used for the removal of bearing (6) .Apply Tooling (F) to the wiper seal groove (1) prior to assembly.Lubricate the sealing lips (2) with the fluid that is being sealed. (4) Torque for the nut ... 2700 270 N m (1990 200 lb ft) (5) Lubricate the threads with clean grease. Torque for the head ... 600 130 N m (442 95 lb ft)Smart Cylinder
(S/N: SHA1-Up; SNL1-Up)
Illustration 9 g01249350
Tooling (C) and Tooling (E) is used for the removal of bearing (4) .Tooling (G) and Tooling (H) is used for the removal of bearing (7) . (1) Torque for the setscrew ... 25 6 N m (18 4 lb ft) (2) Lubricate the sealing lips with the fluid that is being sealed. (3) Apply Tooling (F) to the groove of the wiper seal. (5) Torque for the nut ... 2200 220 N m (1622 162 lb ft) (6) Torque for the head ... 600 130 N m (443 95 lb ft) (8) Torque for the bolt ... 47 9 N m (35 7 lb ft)Installation Procedure
Table 3
Required Tools    
Tool     Part Number     Part Description     Qty    
A     8S-7615     Pin     2    
4C-6486 Stand     2    
8S-7641 Tube     2    
B     1P-5197     Retaining Ring Pliers     1    
Illustration 10 g01250545
Illustration 11 g01250537
Attach a suitable lifting device to stick cylinder (9). The weight of stick cylinder (9) is approximately 91 kg (200 lb). Install stick cylinder (9). Install pins (8) and (12). Install shims (7) and (11). Use Tooling (B) in order to install retaining rings (6) and (10) .
Illustration 12 g01250321
Connect hose assembly (5). Connect clamps (3) and (4). Connect harness assembly (2).
Illustration 13 g01250320
View from the bottom left side of the stick cylinder
Connect hose assembly (1) from the head end of the stick cylinder.
Illustration 14 g01250319
Remove the suitable cribbing from the boom cylinder.
Illustration 15 g01250315
Remove Tooling (A) .