RADIATOR AS 5586913 - Caterpillar

Installation Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Be sure that the pin bores in the boom cylinder, the boom and the upper frame are clean and free of dirt prior to installation of the boom cylinder.
Illustration 1 g00556082
Attach a suitable lifting device to boom cylinder (3). Position the boom cylinder in the upper frame and align the pin bores.
Illustration 2 g00555990
Typical example
Slide the boom cylinder to one side until the boom cylinder makes contact with the mounting flange on the upper frame. Measure the total clearance between the head end of the boom cylinder and the upper frame at the pin bore. The total clearance of Measurement (a) plus Measurement (b) must not be more than 1.0 mm (0.04 inch). If the total clearance is less than 1.0 mm (0.04 inch), the addition of shims between the boom cylinder and frame will not be required. Apply 5P-0960 Molybdenum Grease on pin (5), and install the pin with the nuts and retaining bolt (6).
Illustration 3 g00555049
If the total clearance is more than 1.0 mm (0.04 inch), the addition of shims will be required. Install the shims between the boom cylinder and the upper frame on the side