RADIATOR AS. 7C6286 - Caterpillar

Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury can result from the sudden release of high pressure oil.Be sure the engine has been shut off for a minimum of five minutes to be sure that the accumulator pressure is zero.The accumulator is filled with dry nitrogen. Do not loosen or remove the valve or cap from the top of the accumulator. A purge screw at the bottom of the accumulator can be used to release the pressure that is left in the system.
Note: Put identification on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Apply the parking brake.
Illustration 1 g00277573
Raise the lift arms off the ground by approximately 1.5 m (5 ft). Position Tooling (A) under the lift arms, as shown.
Release the pressure in the hydraulic system. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Illustration 2 g00984591
Remove nuts (1) and cover (2) .
Illustration 3 g00985357
Disconnect harness assembly (7) .
Disconnect hose assemblies (3) and (6) .
Remove nut (4), the washer and solenoid (5) from valve (8) .
Illustration 4 g00985362
Disconnect fitting (9) and remove valve (8) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     8S-7630     Stand     2    
8S-7631 Tube     2    
8S-7615 Pin     2    
8S-8048 Saddle     2    
Illustration 5 g00985362
Position valve (8) and connect fitting (9) .
Illustration 6 g00985357
Install solenoid (5), the washer and nut (4) onto valve (8) .
Connect hose assemblies (3) and (6) .
Connect harness assembly (7) .
Illustration 7 g00984591
Position cover (2) and install nuts (1) .
Illustration 8 g00277573
Raise the lift arms and remove Tooling (A) .
Release the parking brake.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".