AVSPARE.COM
parts catalog

RADIATOR GP 7C8651 - Caterpillar


7C8651 RADIATOR GP Caterpillar parts
Rating:
31
Alternative (cross code) number:
CA7C8651
7C-8651
7C8651
Caterpillar 7C8651 RADIATOR GP
Weight: 0.01 pounds 0 kg.

Buy RADIATOR GP 7C8651 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 1 g01949763
Illustration 2 g01949766
Section A-A
Refer to Disassembly and Assembly, "Final Drive, Brake and Wheel (Rear)" for the assembly for the rim adapter and refer to Tool Operating Manual, NEHS0872, "Preload Procedure" for bearing preload. (1) Torque for the nuts ... 3100 350 N m (2286 258 lb ft) (2) Lubricate the seal assembly lightly with the lubricant that is being sealed. Ensure that the seal assembly is snapped into the groove. Keep the brake hub (3) centered on the seal retainer (5) in order to prevent the damage of the seal assembly on holes of the brake hub during assembly. (4) Lubricate two O-ring seals lightly with the lubricant that is being sealed. (6) Apply 154-9731 Thread Lock Compound to the threads of the bolts. (7) Apply 4C-5592 Anti-Seize Compound to the serrated length of the shank of the stud before pressing into the wheel (8). (9) Install the seal retainer so that one of the cast hole in the seal retainer is in line with the tube of spindle oil. (10) Use the following procedure to tighten the 21 bolts:
Install one half of the total bolts so that the bolts are equally spaced. Tighten the bolts in the alternate sequence to 450 50 N m (332 37 lb ft).
Install the remaining bolts and tighten to 800 100 N m (590 74 lb ft). Turn the bolts to an additional angle of 90 10 degrees.
Tighten the bolts that were installed in step 1 to 800 100 N m (590 74 lb ft). Turn the bolts to an additional angle of 90 10 degrees. Note: Do not use the bolts which are removed after the above setting procedure. Discard the bolts and replace the bolts with new bolts. (11) As required, use the following shim pack in order to fill the gap between the reaction hub and the spindle assembly which allows correct preload on the bearings and a good bolted joint: 139-7624 Shim Pack Thickness of the shim pack ... 3.90 mm (0.154 inch) (12) Torque for the bolts ... 3100 350 N m (2286 258 lb ft)
Illustration 3 g01961040
Detail B
Service and parking brake group
(13) Torque for the taperlock studs ... 1200 150 N m (885 111 lb ft)Note: Torque each nut (14) in one revolution at a time in order to pull down the housing evenly. When all of the nuts bottom out,


Parts radiator Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.