RADIATOR CHANNEL ASSEMBLY 7N3829 - Caterpillar

7N3829 RADIATOR CHANNEL ASSEMBLY Caterpillar parts 16G

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA7N3829
7N-3829
7N3829

Caterpillar 7N3829 RADIATOR CHANNEL ASSEMBLY

Weight: 26 pounds 11 kg.

Buy RADIATOR CHANNEL ASSEMBLY 7N3829 Caterpillar genuine, new aftermarket tractor parts with delivery
MOTOR GRADER,

Compatible equipment models: 7N3829:

MOTOR GRADER 16G Caterpillar

For full view, you need register

Information:

Start By:
Remove the crankcase guard.
Remove the power train guard.
Remove the rear drive shaft.
Remove the rear compactor wheels.
Illustration 1 g03688387
Remove bolts (1) and the washers. Remove cover (2).
Remove two bolts (3) and the washers. Remove two bolts (4) and the washers.
Illustration 2 g03688394
Position a suitable floor jack under bottom rear axle guard (7). The weight of bottom rear axle guard (7) is approximately 66 kg (146 lb).
Remove the bolts, the washers, and plate (5). Repeat this step for the opposite side of the rear axle guard.
Remove bolts (6) and the washers. Repeat this step for the opposite side of the rear axle guard.
Illustration 3 g03688402
Remove bolts (8) and the washers. Use the suitable floor jack to carefully lower bottom rear axle guard (7) and remove from the machine.
Illustration 4 g03688417
Use two people to remove upper rear axle guard (9). The weight of upper rear axle guard (9) is approximately 46 kg (100 lb).
Repeat Steps 1 through 7 for the opposite side of the machine.
Illustration 5 g03688423
Disconnect tube assembly (10) from rear trunnion support (11).
Illustration 6 g03688433
Disconnect tube assembly (12) from front trunnion support (13).
Illustration 7 g03688435
Illustration 8 g03688440
Attach Tooling (A) and a suitable lifting device to oscillating axle (14). The weight of oscillating axle (14) is approximately 2015 kg (4440 lb).
Illustration 9 g03688491
Remove nuts (15) and the spacers. Repeat this step for the opposite side.
Illustration 10 g03688583
Remove nuts (16) and the spacers. Repeat this step for the opposite side.
Illustration 11 g03688440
Illustration 12 g03688626
Typical Example
Use Tooling (A) and the suitable lifting device to lower oscillating axle (14) onto Tooling (B). Remove the suitable lifting device from oscillating axle (14). Use Tooling (B) to move oscillating axle (14) from under the machine.Installation Procedure
Install oscillating axle (14) in the reverse order of removal.
Tighten nuts (15) and (16) to a torque of 450 50 N m (332 37 lb ft). Tighten nuts (15) an additional 120° 10°.