RADIATOR GP 7N4840 - Caterpillar

Illustration 48 g01176354
Press the "Next" key on the Display.
Measure the bucket width. Enter the results in the spaces that are available on the screen.
Illustration 49 g01176355
Press the "Next" key on the Display.
If the bucket you are creating WAS NOT CONFIGURED as a tilt bucket in Step 5, a screen similar to Illustration 50 will appear.
Illustration 50 g01176357
Press the "Finish" soft key in order to accept the data and in order to exit. Go to the "Save Machine Settings" section.
If the bucket you are creating WAS CONFIGURED as a tilt bucket in Step 5, a screen that is similar to Illustration 51 will appear.
Illustration 51 g01454086
Refer to Testing and Adjusting, "Angle Sensor - Calibrate" in order to continue the process.Save Machine Settings
Note: This file should be stored in a safe place so that measure-up and setup will not need to be performed again in the event something happens to the display.
Illustration 52 g01357606
(80) LCD Screen (81) Soft Keys Labels (82) Soft Keys (83) Escape Key (84) Next Key (85) Power Key (86) "+" Key (87) Arrow Keys (88) "-" Key (89) "OK" Key (90) Menu Key (91) Data Card Slot
Hold the "OK" key (89) while pressing the "Power" key (85) in order to start the AccuGrade system in "Service" mode.
Press the "Menu" key (90) .
Use the arrow keys (87) until "Save Settings" is highlighted.
Press the "OK" key (89) .
Use the Arrow keys (87) in order to select "Machine Settings".
Press the "OK" key (89) .
Use the Arrow keys (87) in order to name file, that is, the serial number of the machine.
Press the "OK" key (89) .
Press and hold the "Power" key (85) in order to power down the display.
Remove the flash card from the display. Load the flash card into a computer in order to save the file.Machine Dimensions Table
Use Table 4 in order to record the machine dimensions.
Table 4
Installation Menu     Soft Key     Field     Setting / Value    
Taped Measurements     Stick     Stick Length B-G        
Length D-G
Length D-F
Length F-H
Bucket Linkage Measurements Length B-J        
Length F-G    
Boom Boom Length A-B        
Machine Width    
Height of boom pivot above ground    
Boom range pole target to boom centerline    
GPS Measurements     None     Receiver pole height with adapter        
Main Screen     Soft Key     Field     Setting / Value    
    Create New Bucket [1]     Length G-H        
Length G-I
Length G-J
Width
    Create New Bucket [2]     Length G-H        
Length G-I
Length G-J
Width
    Create New Bucket [3]     Length G-H        
Length G-I
Length G-J
Width