RADIO GP 3721600 - Caterpillar

Table 1
Major Overhaul Instructions (1)
Clean Oil suction screen
Clean
Inspect
Test Aftercooler core (2)
Inspect Alternator
Camshafts
Camshaft thrust washers
Cylinder block
Crankshaft vibration damper
Driven equipment (alignment)
Electronic control module (ECM) (3)
Engine mounts
Engine wiring harness
Flywheel
Front gear train (gears)
Lifters
Rear gear train (gears)
Inspect
Rebuild Rocker arms
Inspect
Rebuild
Exchange Connecting rods
Engine oil pump
Fuel priming pump
Fuel transfer pump
Jacket water pump
Prelube pump
SCAC pump
Starting motor
Turbochargers
Inspect
Rebuild
Replace Camshaft bearings
Crankshaft thrust plates
Electronic thermostat
Oil cooler core
Piston pins
Software (4)
Timing gears
Inspect
Exchange Crankshaft
Cylinder liners
Pistons (Crowns and Skirts)
Inspect
Replace
Install new Fuel pressure regulating valve
high-pressure fuel rail
Pushrods
Quill tubes
Replace Alternator Belt
Connecting rod bearings
Cylinder head assemblies
Exhaust manifold (seals and bellows)
high-pressure fuel pump
Inlet manifold (gaskets and seals)
Main bearings
Piston rings
Exchange
Install new Fuel injectors
(1) For instructions on removal and installation of components, see the Service Manual, "Disassembly and Assembly" module.
(2) For instructions on cleaning the core, see this Operation and Maintenance Manual, "Aftercooler Core - Clean/Test" topic.
(3) Check for damage.
(4) Install new software when a new ECM is installed.