RADIO INTERFERENCE SUPPRESSION GROUP 5R5443 - Caterpillar

Table 1
REQUIRED TOOLS    
Tool     Part Number     Part Description     Quantity    
A     8T-0859     Pressure Gauge (1)     1    
B     6B-3966     Inlet Pipe Assembly     1    
C     5P-2937     O-Ring Adapter     1    
D     3J-7354     O-Ring Seal     1    
E     1U-6602     Photo- Tachometer     1    
( 1 ) Part of 4C-4892 ORFS Fittings Group
Personal injury can result from rotating and moving parts.Stay clear of all rotating and moving parts.Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified.The machine must be parked on a level surface and the engine stopped.
Illustration 1 g00590799
Located Behind the Screed Extension System (1) Reflective tape (2) Vibratory shaft
Make sure that the engine is not running. Attach a piece of reflective tape (1) to the vibratory shaft (2) .
Illustration 2 g00692620
Located Above the Hydraulic Tank
Tighten the needle valve.Note: The vibratory system will not run when the parking brake control is in the ON position. When the needle valve is tightened, the brakes will stay applied with the parking brake control in the OFF position.
Start the engine and run the engine at full RPM. Release the parking brake control.
Illustration 3 g00675723
Operator Console (3) Vibratory control switch
Illustration 4 g00675725
Right Hand Screed Control Box (4) Vibratory control switch
Place vibratory control switches (3) and (4) in the ON position.
Turn the flow control knob counterclockwise to the maximum setting.Note: The vibratory system will not operate in the NEUTRAL position.
Slowly move the propel lever in the forward direction.Note: When the needle valve is tightened, the brakes will remain applied and the machine will not move.
Use 1U-6602 Phototach and record the speed of the vibratory shaft (2). The speed should be 3000 300 RPM.
Loosen the needle valve in order for the brakes to operate normally.