RAIL AS 1973591 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
(A)     8S-7640     Stand     1    
8S-7641 Tube     1    
8S-7615 Pin     1    
8S-8048 Saddle     1    Note: Make sure that the pin bores in the stick and in the boom are clean and free of dirt prior to the installation of the stick.
Apply a thin coat of 5P-0960 Molybdenum Grease on the bearings and on the seals in the stick.
Illustration 1 g00548474
Fasten an appropriate lifting device to the stick. Position the stick on the boom. The weight of the stick, the bucket control linkage and the bucket cylinder is approximately 525 kg (1160 lb).
Align the pin bore in the stick with the pin bores in the boom. Apply a thin coat of 5P-0960 Molybdenum Grease on pin assembly (8). Temporarily install pin assembly (8). Do not remove the lifting device at this time.
Illustration 2 g00550150
(X) Support Pin (Y) Boom (Z) Stick
Slide the stick to one side until the stick makes contact with the boom. Measure the total clearance between the stick and the boom. The total clearance of measurement (a) plus measurement (b) must not be more than 0.8 mm (.03 inch). If the total clearance is less than 0.8 mm (.03 inch), the addition of shims between the stick and the boom will not be required. If the total clearance is more than 0.8 mm (.03 inch), the addition of shims between the stick and the boom will be required.
Remove pin assembly (8), if shims are required. Install the shims that are required between the stick and the boom. Install the shims on the side opposite of retaining bolt (7). Install pin assembly (8) .
Install retaining bolt (7). Tighten the retaining bolt to a torque of 100 20 N m (75