RAIL GP-FUEL 3612883 - Caterpillar

Product Link (3)
This safety message is on the roof of the enclosure, near the antenna for the Cat® Product Link™ communication device.
Before applying (installing battery jumper) battery power, note:There are a few countries for which Product Link is not certified. Ensure local radio compliance before operation, see www.Dealer.cat.com/PL/Certification.Use in blast sites is also restricted. Refer to M0075640 for further details.
Illustration 7 g06250090
This equipment is equipped with a Cat® Product Link communication device. When electric detonators are being used for blasting operations, radio frequency devices can cause interference with electric detonators for blasting operations which can result in serious injury or death. The Product Link communication device should be deactivated within the distance mandated under all applicable national or local regulatory requirements. In the absence of any regulatory requirements Caterpillar recommends the end user perform their own risk assessment to determine safe operating distance.
Electrocution (4)
This safety message is on the enclosure for the control panel.
Illustration 8 g01392482
DANGER: Shock/Electrocution Hazard-Do not operate this equipment or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings will result in serious injury or death.
Do not connect generator to a utility electrical distribution system unless it is isolated from the system. Electrical feedback into the distribution system can occur and could cause personal injury or death.Open and secure main distribution system switch, or if the connection is permanent, install a double throw transfer switch to prevent electrical feedback. Some generators are specifically approved by a utility to run in parallel with the distribution system and isolation may not be required. Always check with your utility as to the applicable circumstances.
Crush (5)This safety message is on the sides of the base.
Illustration 9 g01433231
Crushing hazard! Read and understand the instructions and warnings in the Operation and Maintenance manual. Failure to follow the instructions or heed the warnings could cause serious injury or death.
Hot Surface (6)This safety message is on the sides of the generator set. This safety message is also on the sides of the radiator.
Illustration 10 g01384734
Hot parts or hot components can cause burns or personal injury. Do not allow hot parts or components to contact your skin. Use protective clothing or protective equipment to protect your skin.
Hot Fluid Under Pressure (7)This safety message is located near the cooling system filler cap.
Illustration 11 g01371640
Pressurized system! Hot coolant can cause serious burns, injury or death. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Read and understand the Operation and Maintenance Manual before performing any cooling system maintenance.