RAIL GP-FUEL 3902615 - Caterpillar

Illustration 1 g01449456
(1) Bucket cylinder group (2) Stick cylinder group (3) Bucket control linkage (4) Bucket group (5) Boom groupNote: All bores must be free of paint. Use the 5P-0960 Grease Cartridge in order to coat all bores for pins, the bucket and the cylinder pin bores.Note: Make sure that the sleeve bearings are installed in the bore so that the part numbers of the bearings are facing outward. (6) 273-6814 Sleeve Bearing Quantity ... 2 Inside diameter ... 80.12 0.02 mm (3.154 0.001 inch) Outside diameter ... 95.112 0.011 mm (3.7446 0.0004 inch) Installation depth of the sleeve bearing ... 9.5 0.8 mm (0.37 0.03 inch) (7) 229-1095 Sleeve Bearing Quantity ... 2 Inside diameter ... 60.15 0.04 mm (2.368 0.002 inch) Outside diameter ... 75.085 0.010 mm (2.9561 0.0004 inch) Installation depth of the sleeve bearing ... 9.5 0.8 mm (0.37 0.03 inch) (8) 229-1091 Sleeve Bearing Quantity ... 2 Inside diameter ... 65.19 0.04 mm (2.567 0.002 inch) Outside diameter ... 80.140 0.013 mm (3.1551 0.0005 inch) Installation depth of the sleeve bearing ... 9.5 0.8 mm (0.37 0.03 inch) (9) 127-3913 Pin As Pin diameter ... 59.86 0.03 mm (2.357 0.001 inch) Bore diameter for the pin assembly ... 60.037 0.037 mm (2.3637 0.0015 inch) (10) 1R-6224 Pin As Pin diameter ... 59.86 0.03 mm (2.357 0.001 inch) Bore diameter for the pin assembly ... 60.037 0.037 mm (2.3637 0.0015 inch) (11) Lubricate the sealing lip of the six lip type seals lightly with the lubricant that is being sealed. Install the dust seal so that the lip of the six lip type seals faces outside, as shown. Install the six lip type seals so that the six lip type seals do not extend beyond the face of the boss.