RAIL AS 9J7368 - Caterpillar

If it is necessary to remove broken glass, use thick gloves to prevent injury.
1. Put tool (A) in between the two lips of seal (1) as shown. Move tool (A) along the seal to pull the locking lip of the seal out away from the cab. Move the tool completely around the circumference of the glass. 2. Remove glass (2) from the cab. Remove the seal from the edge of the window opening.Install Cab Window Glass
1. Start along the side of the window panel opening to install seal (1). 2. Install edge (3) of the seal over panel (2) with the locking lip of the seal toward the outside of the cab.3. Install the seal around the circumference of the window opening. Cut the seal to extend past the starting point by 3.18 mm (.125 in.) per foot of window opening circumference. Push the ends of the seal together, and push them over the body panel to make a tight, smooth joint. When the glass is installed, edge (5) must be over glass (4) as shown.
Handle glass carefully.
4. Put the lower corner of glass (6) in the channel of the seal as far as possible. Do not use too much force.5. Move in both directions from the starting point, and lift the glass channel of the seal so that the glass can slip into position. 6. Put a solution of soap and water on the locking lip (7) of the seal.7. Install the curved end of tool (A) between the locking lip and groove (8) at any point away from the joint. 8. Move tool (A) along groove (8) as shown.9. Move the tool completely around the circumference of the seal. The rubber lip will lock into position around the glass.