RATCHET-REVERSE 1U7115 - Caterpillar

Illustration 3 g03401166
Table 3
Item Qty Part Specification Description
17 1 214-2445 Spring Length under test force is 40 mm (1.6 inch).
Test force is 940 100 N (211 22 lb).
Free length after test is 43.04 mm (1.694 inch).
18 1 7Y-4224 Orifice Do not apply sealant.
19 1 267-3741 Actuator Lubricate rolling and sliding surfaces lightly with hydraulic oil.
20 1 322-2018 Actuator Slide Lubricate rolling and sliding surfaces lightly with hydraulic oil.
21 1 158-3504 Control Spool Lubricate rolling and sliding surfaces lightly with hydraulic oil.
22 1 263-7732 Housing As Bore must be free of oil, grease, and chips. Install 124-1555 Plug with ball facing out. Make sure that top of sleeve is not above surface of housing. Press ball into sleeve until ball is below the edge of sleeve 0.40 0.20 mm (0.016 0.008 inch).
23 4 162-2165 Bolt Torque to 2.20 0.25 N m (19.47 2.21 lb in).
24 1 373-1585 Coil Operating voltage is 24 VDC.
Nominal resistance at 25 ° C (77 ° F) is 5.0 0.3 ohms.
25 1 198-2914 Nut Torque to 20 3 N m (177 27 lb in).
26 1 316-1438 Cartridge As Torque to 35 3 N m (26 2 lb ft).
27 1 270-7898 Spring Length under test force is 46.95 mm (1.848 inch).
Test force is 27.22 0.63 N (6.12 0.14 lb).
Free length after test is 57.22 mm (2.253 inch).
28 1 6J-2680 O-Ring Seal Lubricate lightly with lubricant that is being sealed.
29 1 177-1405 Spring Length under test force is 8.20 mm (0.323 inch).
Test force is 18.41 0.55 N (4.14 0.12 lb).
Free length after test is 12.29 mm (0.484 inch).
Illustration 4 g06049098
Table 4
Item Qty Part Specification Description
30 4 232-3868 Belleville Washer As required use the belleville washer and spacer to adjust the clearance:
Thickness of one washer is 3.26 0.15 mm (0.130 0.006 inch).
31 1 357-1728 Spacer Thickness is 2.28 0.05 mm (0.090 0.002 inch).
32 1 214-6489 Ball Lubricate rolling and sliding surfaces lightly with hydraulic oil.