RECEPTACLE AS 1086177 - Caterpillar

Illustration 3 g02960137
Year of ManufactureLocal regulations may require documentation of the Year of Manufacture in the OMM. Comply with these regulations.
Illustration 4 g03007098
The service information number plate (SIN) is located on the inside left post.
Illustration 5 g01640552
Engine Serial Number (6) ____________________Transmission Serial Number (7) ____________________Custom Options (8) ____________________ Stamp "Z"Other machine information is also listed, if necessary.The engine serial number is located on top of the engine valve cover.The following information is stamped on the Serial Number Plate: engine serial number, model and arrangement number.Engine Serial Number ____________________Engine Arrangement Number ____________________Cat dealers need these numbers in order to determine the components that were included with the engine. This information permits accurate identification of replacement part numbers.
Illustration 6 g02962336
The serial number plate for the bulldozer is located at the rear of the bulldozer on the left side.Bulldozer Serial Number ____________________
Illustration 7 g00942536
Ripper Serial Number ____________________The serial number plate for the ripper is located on the right tower of the ripper carriage.
Illustration 8 g01209622
Illustration 9 g01209629
The serial number plate for the winch is located on the right side of the winch case.Winch Serial Number ____________________Certification
ROPS FOPS Certification (9)
The protective structure certification (9) is located on the outside of the right post.
Illustration 10 g02960917
Illustration 11 g01212098
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. This will void the certification. Consult your Cat dealer to determine this structure's limitations without voiding its certification.
This machine has been certified to the standards that are listed on the certification plate. The maximum mass of the machine, which includes the operator and the attachments without payload, should not exceed the mass on the certification plate.Refer to Operation and Maintenance Manual, "Guards (Operator Protection)" for more information. Sound Certification
Illustration 12 g01948477
A typical example of this film is shown. Your machine may have a different value.If equipped, the certification film is used to verify the environmental sound certification of the machine. The value that is listed on the film indicates the guaranteed sound power level. The guaranteed sound power level is measured at the time of manufacture. The guaranteed sound power level is measured according to the conditions that are specified in "2000/14/EC".Product Link
This message is located on the electronic control group of the Product Link module.
Illustration 13 g01057253
Consult your Cat dealer with any questions that concern the installation or the operation of the Product Link.