RECEPTACLE AS-CONNECTOR 1710596 - Caterpillar

Illustration 108 g03009838
Illustration 109 g03009796
Install seal rings (14) and (15) on clutch piston (13) .
Illustration 110 g02997616
Install clutch piston (13) into clutch housing (8) .
Illustration 111 g03013776
Attach Tooling (C) and install ball bearing (12) into clutch housing (8) . Mark the location of Notch (Y) on ball bearing (12) .
Illustration 112 g02992956
Illustration 113 g03013976
Attach a suitable lifting device to Tooling (C) . Install clutch housing (8) . The weight of clutch housing (8) is 84 kg (185 lb). Check that Marks (Y) are aligned. Remove Tooling (C) .
Illustration 114 g02992905
Install bolts (11) in clutch housing (8) . Tighten bolts (11) to a torque of 410 50 N m (302.4 36.9 lb ft).
Illustration 115 g02992877
Attach a suitable lifting device to shaft (9) . slightly raise shaft (9) in order to install retainer (10) .
Illustration 116 g02992836
Install bearing retainer (7) on clutch housing (8) . Install bolts (6) and washers that secure bearing retainer (7) to clutch housing (8) .
Illustration 117 g02992798
Install O-ring seals (5) .
Illustration 118 g03014722
Use the following procedure to make sure that the clutch pistons move within the clutch housings.
Apply shop air pressure, using Tooling (M) (not shown) to each of the five Oil Passages (X) . The air pressure must be free of water and the air pressure must not exceed 690 to 1025 kPa (100 to 150 psi).
If the clutch pistons do not move, apply a small amount of clean hydraulic oil in the Oil Passage (X) . Check for movement again. If the clutch pistons do not move, the transmission must be disassembled in order to determine the cause.
Illustration 119 g02992785
Install O-ring seal (4) on case assembly (1) .
Illustration 120 g02992560
Attach Tooling (C) to case assembly (1) . Attach a suitable lifting device and Tooling (B) to Tooling (C) . Secure the suitable lifting device to a hoist. Install case assembly (1) on support housing assembly (3) . The weight of case assembly (1) is 204 kg (450 lb).
Install bolts (2) that secure case assembly (1) to support housing assembly (3) .
Illustration 121 g02992540
Separate case assembly (1) from Tooling (A) .End By:
Install the hydraulic control valve.
Connect the transmission and the output transfer gears.