RECEPTACLE AS 3463510 - Caterpillar

"Engine Serial Number"
The "Engine Serial Number" should be programmed in order to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM."Full Load Setting" (FLS)
"Full Load Setting" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information ratings plate. This value should only be changed if the engine is rerated or a new ECM is installed. Factory passwords are required."Full Torque Setting" (FTS)
"Full Torque Setting" is similar to "Full Load Setting". This value should only be changed if the engine is rerated or a new ECM is installed. Factory passwords are required."Product ID"
The "Product ID" parameter allows the customer to enter a description into the ECM in order to identify the machine. A maximum of 8 characters can be entered in the field."Equipment ID"
The "Equipment ID" parameter allows the customer to enter a description into the ECM in order to identify the machine. A maximum of 17 characters can be entered in the field."Throttle Lock Engine Speed Limit"
The "Throttle Lock Engine Speed Limit" allows the customer to enter a maximum engine speed (rpm) for the throttle lock."Ether Control"
The "Ether Control" parameter allows the operation of this feature to be enabled or disabled."Eng Retarder Con"
The "Eng Retarder Con" parameter allows the operation of this feature to be enabled or disabled.Parameters Table
Table 1
System Configuration Parameters
Parameter Available Range or Options Default Required Password
"Product ID" 8 characters blank none
"Equipment ID" 17 characters blank none
"Engine Serial Number" 8 characters blank Factory
"FLS" -128 to +127 0 Factory
"FTS" -128 to +127 0 Factory
"Throttle Lock Engine Speed Limit" 850 to 3000 2250 none
"Ether Control" "Enable"/"Disable" "Disable" none
"Eng Retarder Con" (if equipped) "On"/"Off" "Off" none Parameters Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters
"Product ID"
"Equipment ID"
"Engine Serial Number"
"ECM Part Number"
"ECM Serial Number"
"Software Group Part Number"
"Software Group Release Date"
"Software Group Description"
"FLS"
"FTS"
"Throttle Lock Engine Speed Limit"
"Ether Control"
"Total Tattletale"
"Eng Retarder Con"
(if equipped)
Table 3
Information From Engine Information Plate
Engine Serial Number
Full Load Setting
(for new ECM)
Full Torque Setting
(for new ECM)
Note: Compare the FLS and the FTS from the ECM with the values that are listed on the Engine Information Plate. The FLS and the FTS should only be changed because of a mechanical change in the engine. The use of the wrong parameters could cause damage to the engine. The use of the wrong parameters may also void the Caterpillar warranty.