RECTIFIER 1104424 - Caterpillar

Stopping the engine immediately after it has been working under load can result in overheating and accelerated wear of engine components.Excessive temperatures in the turbocharger centerhousing will cause oil coking problems. Excessive temperatures in the turbocharger centerhousing may damage the turbocharger bearing/shaft system and significantly shorten the life of the turbocharger.Allow the engine to gradually cool before stopping the engine
Open the main circuit breaker in order to disengage the driven equipment.
Use one of the following methods in order to stop the engine:
For all control panels, turn the engine control switch to the "OFF/RESET" position. The engine will immediately shut off.
For engines with the EMCP II, EMCP II+or the EMCP II+P control panel, the engine control switch may be turned to the "COOLDOWN/STOP" position. If the cooldown feature is utilized, the engine will operate for a programmed period of time before the engine stops. Otherwise, the engine will immediately shut off.
For engines with the Switchgear Conversion control panel, the engine will stop if the engine control switch is turned to the "Service" position. The Caterpillar Monitoring System will remain energized. This position of the engine control switch is used in order to program the Caterpillar Monitoring System.
For engines with the EMCP3 control, the operator must press the red "STOP" button on the EMCP3 controller. If the setpoint for the duration of the cooldown period is set to a value that is greater than zero, the engine will operate for a programmed period of time before the engine stops. Otherwise, the engine will immediately shut off.Automatic Stopping
Automatic stopping will occur when the engine is operating in the automatic mode and the remote start/stop initiate contact opens. If the cooldown feature is utilized, the engine will operate for a programmed period of time before the engine stops. Otherwise, the engine will immediately shut off.