REDUCER AS 5100550 - Caterpillar

HOLD Position
Illustration 1 g02188213
HOLD position for the stick valve (1) Spring (2) Spool (3) Pump passage (4) Chamber (5) Check valveThe stick control valve is located between the bucket control valve and the extendable stick control valve. In the HOLD position, spring (1) keeps spool (2) in the centered position. Oil from the pump flows from passage (3) into chamber (4). In the HOLD position, spool (2) blocks the flow of oil. Check valve (5) will maintain pressure in the line in order to avoid cylinder drift. Refer to this Systems Operation, "Load Check Valve" for more information.STICK IN Position
Illustration 2 g02188215
STICK IN position for the stick valve (1) Port to the rod end of the cylinder (2) Chamber for signal oil (3) Compensator spool (4) Chamber (5) Port to the head side of the cylinder (6) Passage (7) Check valve (8) Signal oil passage (9) Passage (10) Passage (11) Passage (12) Passage (13) Pump passage (14) Chamber (15) Spool (16) Spring (17) Passage (18) Check valve (19) Spring (20) Makeup and relief valve (21) Passage (22) Resolver network (23) Spring chamberWhen you move the spool (15) to the left, the spring (16) is compressed toward the left. Oil from the pump flows from passage (13) into chamber (14). The oil flows around spool (15) into passage (11). As the oil flows into passage (11), the oil acts against the compensator spool (3). As the oil pressure increases, the spring of compensator (3) compresses and the compensator spool (3) moves up.The oil flows around the compensator spool (3) into passage (10). Oil from passage (10) then enters the signal oil passage (8). The signal oil goes from the signal oil passage (8) into the resolver network (22). If this circuit is the only active circuit, or if this circuit has a work port pressure that is higher than the other circuits that are active, the oil pressure from this circuit will flow to the chamber for signal oil (2). The pump actuator will receive a signal in order to control the output from the pump. Refer to this Systems Operation, "Signal Network Resolver" for more information. The oil pressure in the chamber for signal oil (2) and the pressure of the compensator spring (3) balances oil pressure in passage (13) .When the oil enters passage (10), oil on the left side of passage is blocked by spool (15). On the right side of passage (10), the oil flows around spool (15) into passage (9). The oil goes from passage (9) past the check valve (7) and into passage (6). Refer to this Systems Operation, "Makeup and Relief Valve" for more information. The oil then flows through port (5) to the head side of the cylinder. This will extend the cylinder. This returns the stick to the STICK IN position.Return oil flows from the rod end of the cylinder through port (1). The oil goes from port (1) into passage (21). The oil moves from passage (21) past the makeup and