REGULATOR 1058405 - Caterpillar

Table 1
Parameter Value    Parameter Name    Explanation of Parameter    
"00P"     Control module software     Software version 6.7 and lower versions operate the evaporator core at
2.2 °C (36 °F). Version 7.0 operates the evaporator core at
-0.5 °C (31 °F). (1)    
"01P"     Direct sunlight     A number between 10 and 20 will be displayed for no sunlight. A number between 200 and 250 will be displayed for full sunlight.    
"02P"     Air door (Door Assembly)     A numeric value will indicate the position of the air door. 255 is closed. Travel range is from 0 to 14. 14 is fully open.    
"03P"     Air temperature in the cab     The control panel displays temperatures in Degrees Celsius or in Degrees Fahrenheit.    
"05P"     External temperature (Ambient air)     The external ambient air temperature is displayed in Degrees Celsius or in Degrees Fahrenheit.    
"06P"     Air temperature from the vents (Cab air)     The air temperature from the vents is displayed in Degrees Celsius or in Degrees Fahrenheit.    
"07P"     Blower fan cold start offset temperature     Offset temperature for a cold starting auto blower at a high speed with a vent temperature that is above the cab temperature plus the offset temperature.    
"08P"     The cutoff temperature for the compressor that is from the temperature sensor (Evaporator)     The cutoff temperature from the evaporator coil is displayed in Degrees Celsius or in Degrees Fahrenheit.    
"10P"     "COOL_ON"     The temperature above the setpoint that is required to turn ON the compressor is displayed.    
"11P"     "COOL_OFF"     The temperature below the setpoint that is required to turn OFF the compressor is displayed.    
"12P"     Auto blower high speed threshold     The temperature difference that is required to turn the blower to high speed is displayed.    
"14P"     Sun bias     The maximum temperature offset due to full sunlight is displayed. The value is displayed in a percentage.    
"15P"     Compressor fan over current status     0 is displayed for a normal current. 1 is displayed for an overcurrent.    
"16P"     Blower fan over current status     0 is displayed for a normal current. 1 is displayed for an overcurrent.    
"17P"     Transition from A/C to Heat     The negative temperature difference that is required to change from A/C mode to Heat mode after 2 minutes    
"18P"     Transition from Heat to A/C after short delay     The positive temperature difference that is required to change from Heat mode to A/C mode after 10 seconds    
"19P"     Transition from Heat to A/C after long delay     The positive temperature difference that is required to change from Heat mode to A/C mode after a long delay    
"20P"     Cab temperature change factor     Cab temperature factor is value 10.    
"36P"     Evaporator temperature     This indicates the actual value of the temperature sensor (evaporator) in Degrees Celsius or in Degrees