REGULATOR-TEMPERATURE 1209453 - Caterpillar

Electric Power Generation:
All Engine: Industrial, Marine, and Generator Set that Use Flash Programming
AllReferenceSystems Operation, Troubleshooting, Testing and Adjusting, RENR8091ReferenceSpecial Instruction, REHS2362ReferenceElectronic Media CD"EERP1000"Flash File 342-2512
342-2512 Communication Software Gp has been released as a direct replacement for the existing 315-0627 Communication Software Gp. The 342-2512 Communication Software Gp provides the same functionality as the 315-0627 Communication Software Gp with several new features and enhancements.New Features
An Embedded Communications Adapter is used for J1939 Flashing and Servicing.
The PL1000E Webpage now includes a "RS-485 4/2 Wire configuration" selection.
J1939 Diagnostics to Webserver is now available.
The default configuration has changed to the values that are shown in Table 1.
Table 1
Parameter     Value    
"Modbus Ports"     "Enabled"    
"Internet Protocol Addressing"     "Static Addressing"    
"IP"     "192.161.1.1"    
"Mask"     255.255.255.0    
"Gateway"     0.0.0.0    Enhancements
The "Rolling Reset Security Condition" has been removed. This removes the ".pcl" file from use when five power cycles occur within a time period of 60 seconds or less.
The resetting of the PL1000E to "Defaults Security Condition" which occurred during power cycling has been removed.
The "Custom Webpage Lockup" which occurred over time has been corrected.
The "Active Events Sustained After Power Cycle" functionality has been corrected.
The "DHCP Gateway Address" which would increase by a value of 1 in the fourth octet has been corrected.
The PL1000E will only accept configurations of the baud rate that are valid.
The ".PCL File Extension" is no longer case sensitive.