REGULATOR GP-GAS PRESSURE 1262809 - Caterpillar

Engine Starting Above 0°C (+32°F)
1. Move the propel control lever to NEUTRAL. 2. Push parking brake knob (1) down to apply the parking brake. 3. Move the accelerator handle to the low idle position. 4. Turn engine start switch key (2) to start the engine. Release engine start switch key (2) when the engine starts.
Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again.
For starting at temperatures below 0°C (+32°F), the use of additional optional starting aids is recommended. Extra battery capacity may be required. At temperatures below -23°C (-10°F), consult your Caterpillar dealer, or refer to the Operation & Maintenance Manual for Cold Weather Recommendations, Form SEBU5898, available from your Caterpillar dealer.Engine Starting with Jump Start Cables
Batteries give off flammable fumes that can explode resulting in personal injury.Prevent sparks near the batteries. They could cause vapors to explode. Do not allow jump start cable ends to contact each other or the machine. Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear eye protection when starting a machine with jump start cables. Improper jump start procedures can cause an explosion resulting in personal injury.Always connect the battery positive (+) to battery positive (+) and the battery negative (-) to battery negative (-).Jump start only with a battery source with the same voltage as the stalled machine.Turn off all lights and accessories on the stalled machine. Otherwise, they will operate when the jump source is connected.
When starting from another machine, make sure the machines do not touch. This could prevent damage to engine bearings and electrical circuits.Severely discharged maintenance free batteries will not fully recharge from the alternator alone after jump starting. These batteries must be charged to the proper voltage with a battery charger. Many batteries, thought to be unusable, are still rechargeable.This machine has a 12 volt starting system. Use only equal voltage for jump starting. Use of a higher voltage will damage the electrical system. Refer to Special Instruction, Battery Test Procedure, SEHS7633, available from your Caterpillar dealer, for complete testing and charging information.
Use of Jump Start Cables
When auxiliary start receptacles are not available, use the following procedure.1. Make initial determination as to failure of machine to crank. Refer to Special Instruction SEHS7768 on use of 6V-2150 Starting/Charging Analyzer Group. Procedure applies even if machine does not have diagnostic connector.2. Place the propel control lever in NEUTRAL on the stalled machine. Apply the parking brake.3. On stalled machine, turn the engine start switch key to OFF. Turn off all accessories.4. On stalled machine, turn on (close) the disconnect switch (if equipped).5. Move electrical source (machine) near enough to stalled machine for the jump start cables to reach. But, do not allow machines to touch.6. Stop the engine on the electrical source machine. Or, if using an auxiliary power source, turn off the charging system.7. Make sure battery caps are