REGULATOR AS 2298870 - Caterpillar

Assemble receptacle kit (23) onto coil (20).
Illustration 2 g06068772
(19) 255-2752 Start Switch Gp
(20) 205-8257 Coil
(24) 350-8461 Switch Panel
Assemble start switch (19), coil (20), and switch panel (24). Orient the key slot as shown in Illustration 2. Secure the coil to the switch panel with the nut on the start switch. Tighten to 13.6 4 N m (10 3 lb ft).
Illustration 3 g06069024
(1) 310-5289 Machine Electronic Control Module
(2) 7X-2533 Bolt
(3) 338-6837 Bracket As
(7) 8C-5607 Isolation Mount
(10) 8C-5608 Spacer
(11) 9X-6165 Washer
Attach control module (1) to bracket (3). Use two bolts (2), two washers (11), two spacers (10), and four isolation mounts (7) to secure the module.
Illustration 4 g06069044
(A) Side panel
Remove side panel (A) from the right side of the cab.
Illustration 5 g06069058
(9) 9X-2042 Screw
Secure the control module assembly to the cab using two screws (9). Tighten the screws to 1.7 0.4 N m (15 3.5 lb in).
Remove the existing start switch cover plate and remove the existing start switch.
Illustration 6 g06069086
(16) 8C-7581 Screw
(18) 096-6166 Hard Washer
Place the new start switch into position. Secure the switch panel to the dash using two screws (16) and washers (18). Tighten the screws to 6 1 N m (53 9 lb in).
Illustration 7 g06069084
(B) Coil connector
(C) Cab harness connector
(D) Control module connector
(E) Cab harness connector
(12) 350-8490 Power Harness As
(13) 353-1910 Cover
(14) 363-9619 Cover
(17) 3S-2093 Cable Strap
Install harness (12). Connect coil connector (B), cab harness connector (C), control module connector (D), and cab harness connector (E).
Secure the harness at two locations using cable strap (17).
Install cover plate (13) or (14). Cover (13) is for machines equipped with the engine stop (shutdown) feature. For machines not equipped with this function, install cover (14).Note: The cover cannot interfere with the start switch. Ensure that there is no interference.
Illustration 8 g06069099
(5) 205-0826 Film
Install film (5) using the dimensions shown in Illustration 8.
Install 198-5389 Film or 200-5125 Film around the start switch. Film 200-5125 is for machines equipped with the engine stop (shutdown) feature. For machines not equipped with this function, install film 198-5389.
Illustration 9 g06069118
(15) 205-0826 Film
Install film (15) on the lower corner of the cab door near the door handle.
Assemble each 099-3629 Key Ring and 285-3231 Electronic Key As. Place each 219-6607 Film onto each key.
Set up the MSS. Refer to the "Special Instruction" referenced below. Refer to the topic "Setup of the Machine Security System".
After setting up the system and checking functionality, install any covers that were removed.