REGULATOR AS-GAS PRESSURE 3770007 - Caterpillar

Machine instability can result in injury or death. To ensure stability during operation the following conditions must be observed:Tires must be correctly inflated and have the correct amount of ballast (if equipped).The machine frame must be level.The frame level switch must never be operated when the boom is raised.The frame level switch must never be operated when stabilizers are lowered.Stabilizer switches must never be operated when the boom is raised.The correct load chart for the machine as equipped must be referenced and the weights and load centers specified must never be exceeded.The machine must never be moved when the boom is raised.
Illustration 1 g00955167
The load charts are located on the dash panel at the right side of the instrument cluster. Ensure that the correct load chart is used. The chart is intended for the type of attachment that is represented by a symbol at the top of the chart. Symbols are also shown for operation on tires or on stabilizers. The load charts may be in metric units (meters and kilograms) or conventional units (feet and pounds).When the machine is operated on tires, the weight of the intended load determines the maximum height above ground. The weight of the intended load also determines the maximum distance that is between the load center of gravity and the front wheels.When the machine is operated with lowered stabilizers, the weight of the intended load determines the maximum height above ground. The weight of the intended load also determines the maximum distance that is between the load center of gravity and the stabilizer pads.The machine boom has two scales which must be used for reference with the load chart in order to assess the lift operation. The boom extension reference scale gives an indication of the boom length. The letters "B", "C" and "D" correspond to the same letters on the load chart. The letter "A" on the load chart corresponds to the fully retracted position of the boom. The letter "E" on the load chart corresponds to the fully extended position of the boom.
Illustration 2 g00955168
Boom angle reference scale (1) gives an indication of the angle of the boom.Follow the instructions below in order to assess the intended load:
Carefully position the machine. The machine should be as close as possible to the intended load. For more information on operating the machine, refer to the appropriate topic in the Operation Section of the Operation and Maintenance Manual.
In order to move the attachment into position for the operation, raise the boom and extend the boom, as required. Do not make the lift operation.
Look at the boom extension reference scale and the boom angle reference scale and note the readings. Refer to the load chart and use these two values in order to locate the equivalent load zone.
If the intended load is equal to the value in the equivalent load zone the lift