REGULATOR-WATER TEMPERATURE 5248612 - Caterpillar

4. Disconnect the lubrication hose from the inboard pillow block bearing, slide the belt band over the fan, then move the belt band away.
NEVER PRY A BELT BAND ONTO A PULLEY OR SHEAVE, OR THE BELT BAND WILL BE DAMAGED.
5. Slide the new belt band over the fan and onto the sheaves. Connect the lubrication line to the bearing.6. Turn the adjusting nut until a force of 60 pounds (27 kg) applied to the belt band midway between the sheaves produces a belt deflection of 7/16 inch (11 mm).7. Install the belt guard.Replacing The Air Compressor Drive Belt
STARTING OF THE ENGINE CAN CAUSE INJURIES TO ANYONE WORKING ON THE COMPRESSOR BELT. SHUT THE ENGINE DOWN, TAG THE ENGINE CONTROL AND LOCK THE MAIN BATTERY SWITCH AT "OFF" BEFORE CHANGING THE BELT.
1. Loosen the mounting bolts and turn the adjusting nuts to relieve the tension in the air compressor drive belt.2. Slide the belt off the pulleys.
NEVER PRY A BELT ONTO A PULLEY OR SHEAVE, OR THE BELT WILL BE DAMAGED.
3. Slide the new belt onto the pulleys. 4. Turn the adjusting nuts until a force of 5 pounds (2.3 kg) applied to the belt midway between the pulleys produces a belt deflection of 1/4 inch (6.4 mm), then tighten the mounting bolts.5. Start the engine and run it for 15 seconds to seat the belt then retighten the belt.6. Check the belt tension again after 1/2 hour of operation and after the first day. Thereafter, check the tension every 200 hours of operation.Replacing The Water Spray System Pump Drive Belt
STARTING OF THE ENGINE CAN CAUSE INJURIES TO ANYONE WORKING ON THE PUMP BELT. SHUT THE ENGINE DOWN, TAG THE ENGINE CONTROL AND LOCK THE MAIN BATTERY SWITCH AT "OFF" BEFORE CHANGING THE BELT.
1. Loosen the pump bracket mounting bolts. Loosen the jam nut and turn the