REGULATOR AS 5613457 - Caterpillar

Removal Procedure
Start By:
Relieve the hydraulic pressure in the system. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 1 g00744821
Open the engine hood.
Illustration 2 g00886963
Loosen nut (1) and remove the relief valve from the filter base.
Illustration 3 g00887222
Remove O-ring seals (2), (3), and (4) from relief valve (5) .Installation Procedure
Illustration 4 g00887222
Install O-ring seals (4), (3), and (2) on relief valve (5) .
Illustration 5 g00886963
Install relief valve (5) in the filter base. Tighten nut (1) to a torque of 118 10 N m (87 7 lb ft).
Close the engine hood.