AVSPARE.COM
parts catalog

RELAY, STARTER 0003339 - Caterpillar



0003339 RELAY, STARTER Caterpillar parts WE-601B RELAY
Rating:
14
Alternative (cross code) number:
CA0003339
000-3339
0003339
Caterpillar 0003339 RELAY, STARTER

Buy RELAY, STARTER 0003339 Caterpillar genuine, new aftermarket tractor parts with delivery
WINDROW ELEVATOR,

Compatible equipment models: 0003339:

WINDROW ELEVATOR  WE-601B   Caterpillar
Number on catalog scheme: 25
 
  For full view, you need register

Information:


Illustration 1 g01478052
This diagnostic code is associated with the Auto/Manual Switch for the left side of the Motor Grader. The FMI 03 diagnostic code is activated when the Implement ECM detects an above normal voltage of the circuit. The following conditions could cause this diagnostic code to be activated:
The switch has failed.
The normally closed circuit of the switch is open.
The ground circuit of the switch is open.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Clear these created diagnostic codes when the original diagnostic code has been corrected. Verify that the diagnostic code of CID 2258 FMI 03 is active before performing this procedure.Note: Use a 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code is active the hydraulic control system will default to the "Auto Not Allowed" state.Test Step 1. CHECK THE SWITCH
Turn the disconnect switch to the OFF position.
Turn the key start switch to the OFF position.
Disconnect the machine harness connector from the switch.
Use the Multimeter to verify the proper operation of the switch. Refer to Table 1 for the switch operation.
Table 1
Contacts A to B    Contacts C to B    Switch Status    
Less than 5 ohms     Greater than 5000 ohms     Switch Not Pressed    
Greater than 5000 ohms     Less than 5 ohms     Switch Pressed    Expected Result:The switch is operating correctly.Results:
OK - The switch is operating correctly. Proceed to Test Step 2.
NOT OK - The switch is not functioning correctly. There is an internal failure in the switch.Repair: Replace the switch.STOPTest Step 2. CHECK THE NORMALLY OPEN CONTACTS AND NORMALLY CLOSED CONTACTS OF THE SWITCH CIRCUITS IN THE HARNESS
The key start switch and the disconnect switch remain in the OFF position.
Disconnect the machine harness connectors from the ECM.Note: The switch remains disconnected.
At the connector for the switch, connect a jumper wire between contact A and contact B.
At the machine harness connector for the ECM, measure the resistance from contact J2-59 (wire Y937-PU) and contact J2- 60 (wire J771-BU).Expected Result:The resistance is less than 5 ohms.Results:
OK - The resistance is less than 5 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5000 ohms. The circuit is open.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK THE GROUND CIRCUIT OF THE SWITCH IN THE HARNESS
The key start switch and the disconnect switch remain in the OFF position.
The machine harness connectors remain disconnected from the ECM and the switch.
Remove the jumper that was installed in the previous step.
At the connector for the switch, place a jumper between contact A and contact C.
At the machine harness connector for the ECM, measure the resistance from contact J2-22 (wire H745-BR) and contact J2- 60 (wire J771-BU).Expected Result:The resistance is less than 5 ohms.Results:
OK - The resistance is less than 5 ohms. The machine harness is correct. Proceed to Test Step 4.
NOT OK - The resistance is greater than 5000 ohms. There

Caterpillar parts catalog:

Caterpillar parts catalog
WE-601B WINDROW ELEVATOR 7EC00168-UP (MACHINE)


Parts relay Caterpillar catalog:

1456907 RELAY
320B, 322B LN, 325B L, 330B L, 345B II, 345B L
1603600 RELAY
320B FM LL, 320C FM, 325B L, 325C, 325C L, 325D MH, 330B L, 330C L, 330C MH, 330D MH, 345B, 345B II, 345B II MH, 345C, 345C MH, 350 L, 365B, 365B II, 365C L MH, 375 L, 385C L MH, M325B, M325C MH, M325...
1735455 RELAY
320B FM LL, 320C FM, 325B L, 325C, 325C L, 325D MH, 330B L, 330C L, 330C MH, 330D MH, 345B, 345B II, 345B II MH, 345C, 345C MH, 350 L, 365B, 365B II, 365C L MH, 375 L, 385C L MH, M325B, M325C MH, M325...
1603602 RELAY
320B FM LL, 320C FM, 325B L, 325C, 325C L, 325D MH, 330B L, 330C L, 330C MH, 330D MH, 345B, 345B II, 345B II MH, 345C, 345C MH, 350 L, 365B, 365B II, 365C L MH, 375 L, 385C L MH, M325B, M325C MH, M325...
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.