REMOTE CONTROL VALVE 0961635 - Caterpillar

START BY:a) remove electric starting motorb) remove flywheel 1. Loosen bolts (2) that hold the oil pan and plate to the cylinder block. Remove bolts (1) that hold the oil pan plate to the flywheel housing. 2. Fasten a hoist to the rear of the engine. Lift the rear of the engine and install shims (3) between the cylinder block and the oil pan plate on each side of the engine. 3. Remove two bolts and install two 1/2"-13 NC guide bolts (5) in the cylinder block.4. Install tooling (A) and a hoist and remove the remainder of the flywheel housing mounting bolts and housing (4). The weight of the housing is 85 lb. (39 kg).Install Flywheel Housing
1. Clean the old gasket from the surfaces of the cylinder block and flywheel housing that make contact with each other. 2. Install two 1/2"-13 NC guide bolts (1) in the cylinder block as shown. Install tooling (A) and a hoist on the flywheel housing and install it in position on the guide bolts. Install all but two bolts in the flywheel housing. Remove tooling (A) and guide bolts. Install the other two bolts. Tighten the flywheel housing in the bolt sequence as shown.
Typical Example 3. Cut the bottom of the gasket even with the flywheel housing and cylinder block. Put 5H2471 Gasket Cement on the bottom of the gasket for the oil pan plate. Remove shims (2) from each side of the engine. Tighten all of the oil pan bolts. Install the bolts that hold the oil pan plate to the flywheel housing.END BY:a) install flywheelb) install electric starting motor