REPAIR BENCH- 1274904 - Caterpillar

Illustration 3 g00852969
Oil grade plugs being shipped with the engine.
(1) Identification tag for 10W30 oil grade plug
(2) Identification tag for 15W40 oil grade plug
Illustration 4 g00852892
214-7170 Repair Kit
(3) 10W30 oil grade plug (Green wire)
(4) 15W40 oil grade plug (Red wire)
(5) 0W20 oil grade plug (Black wire) 10W30 and 15W40 oil grade plugs are shipped with the engine. The 0W20 oil grade plug can be ordered from the parts manual. Order the 214-7170 Repair Kit. The 0W20 oil grade plug can be made from a 175-3700 Connector Repair Kit. For the correct pin connections, refer to the Electrical Schematic or refer to Table 2.
Table 2
OIL GRADE PLUGS (214-7170)
Plug Oil Grade Wire Color Pin Connections
3 10W30 Green B-C
4 15W40 Red A-C
5 0W20 Black A-B-C Procedure for Changing Engine Oil and Filter
Note: If the sulfur content in the fuel is greater than 1.5 percent by weight, use an oil that has a TBN of 30 and reduce the oil change interval by one-half.Park the machine on a level surface. Stop the engine.Note: Drain the crankcase while the oil is warm. This allows waste particles that are suspended in the oil to drain. As the oil cools, the waste particles will settle to the bottom of the crankcase. The particles will not be removed by draining the oil and the particles will recirculate in the engine lubrication system with the new oil.
Illustration 5 g00101627
The drain valve for the engine crankcase oil is located under the rear of the upper structure. Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on Containing Fluid Spillage.
Illustration 6 g00832244
Open the crankcase drain valve. Allow the oil to drain into a suitable container. Note: Discard any drained fluids according to local regulations.
Close the drain valve.
Open the access door at the right side of the machine.
Illustration 7 g00832246
Remove the oil filter with a strap type wrench. See Operation and Maintenance Manual, "Oil Filter - Inspect". Dispose of the used filter according to local regulations.
Clean the filter housing base. All of the seal material must be removed.
Illustration 8 g00101502
Apply a thin coat of engine oil to the new filter seal.
Place the new engine oil filter onto the base. Rotate the engine oil filter until the filter seal contacts the base. Note the position of the index marks on the filter relative to a fixed point on the filter base. Note: Index marks on the engine oil filter are separated by 90 degrees or 1/4 of a rotation.
You may need to use a Caterpillar strap wrench or another suitable tool in order to tighten the filter. Use the instructions that are printed on the filter in order to tighten the filter. Use the rotation index marks as a guide. Do not damage the filter with the installation tool. Note: If you install a filter that has not been provided by Caterpillar, use the instructions that were provided with the filter.
Close the access door.
Unlatch the engine hood and raise the engine hood.
Illustration 9 g00832234
Remove the oil filler plug . Fill the crankcase with