REPAIR KIT 5W7515 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     -     Threaded Rod
3/8" - 16 NC by 6"     2    
8T-4896 Hard Washer     2    
9S-8752 Full Nut     2    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g01288127
Install plugs (12), the O-ring seal, cover (13), and bolts (14) to valve body (4) .
Illustration 2 g01288115
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install poppet (8), spring (9), retainer (10), and retaining ring (11) in spool assembly (5) .
Illustration 3 g01288114
Illustration 4 g01288113
Illustration 5 g01288111
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install spool assembly (5), spacer (6), and spring (7) in valve body (4) .
Use Tooling (A) to install cover (2) and the O-ring seal against valve body (4) .
Remove one set of Tooling (A) and install bolt (1) .
Remove the other set of Tooling (A) and install bolt (3) .End By: Install the relief valve for the torque converter inlet. Refer to Disassembly and Assembly, "Relief Valve (Torque Converter Inlet - Install".