RESISTOR AS 2395818 - Caterpillar

Install O-ring seals (37) onto solenoid (12).
Illustration 7 g01361712
Install O-ring seals (36) onto solenoid (9).
Illustration 8 g01361708
Install O-ring seals (35) onto check valve (10).
Illustration 9 g01361686
Install O-ring seals (34) onto check valve (7).
Illustration 10 g01361670
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install plug (33). Install retainer (32). Install spring (31). Install retainer (30). Install cover (29). Install bolts (28). Tighten bolts (28) to a torque of 12 3 N m (9 2 lb ft).
Illustration 11 g01361658
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install spool (27). Install plug (26). Install retainer (25). Install spring (24). Install retainer (23). Install cover (22). Install bolts (21). Tighten bolts (21) to a torque of 12 3 N m (9 2 lb ft).
Illustration 12 g01361643
Install pistons (20).
Illustration 13 g01361634
Install plug (19). Install spool (18). Install spring (17). Install ball (16). Install spring (15). Install plug (14). Tighten plug (14) to a torque of 5 1 N m (44 9 lb in).
Illustration 14 g01361587
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install plug (13). Install solenoid (12). Tighten solenoid (12) to a torque of 5.5 1.5 N m (49 13 lb in). Install bolt (11). Tighten bolt (11) to a torque of 12 3 N m (9 2 lb ft). Install check valve (10). Tighten check valve (10) to a torque of 80 15 N m (59 11 lb ft). Install solenoid (9). Tighten solenoid (9) to a torque of 5.5 1.5 N m (49 13 lb in). Install bolt (8). Tighten bolt (8) to a torque of 12 3 N m (9 2 lb ft). Install check valve (7). Tighten check valve (7) to a torque of 80 15 N m (59 11 lb ft). Install plug (6).
Illustration 15 g01361574
Install seal (5). Install control valve (4).
Repeat Step 6 through Step 15 for the remaining control valves.
Install seal (3). Install cover (2).
Illustration 16 g01361509
Install new nuts (1). Tighten nuts (1) in a crisscross pattern to a torque of 25 2.5 N m (221.3 22.1 lb in). Ensure that each nut (1) remains torqued to 25 2.5 N m (221.3 22.1 lb in). Note: Do not reuse nuts that have been torque turned. Replace nuts (1) when servicing the bank valve.
Tighten each nut (1) by an additional 90° 10° in the opposite crisscross pattern. End By:
Install the bank valves. Refer to Disassembly and Assembly, "Bank Valve - Install".