RETAINER 0014785 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
F     1P-0520     Driver Group     1    
G     1U-8842     Seal Installer     1    
H     9U-6600     Hand Hydraulic Pump     1    
6V-3170 Cylinder Group     1    
373-9825 Spacer     1    
2H-1537 Bolt     1    
4C-9471 Adapter     1    
3H-0467 Washer     1    
J     1U-8846     Gasket Sealant     1    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g00423125
Raise the temperature of bearing cones (1) and install bearing cones (1) .
Install bearing cones (1) on the pinion shaft until bearing cones (1) make contact with the shoulders that are on the shaft.
Install pinion shaft (2) in the final drive case.
Illustration 2 g00423126
Use Tooling (F) in order to install the bearing in the cage.
Install the ring that holds the bearing in position.Note: Make sure that the hole in the bearing is in alignment with the hole that is in the cage.
Illustration 3 g00423127
Install dowel (3) in the cage and into the bearing.
Install a new plug over the dowel.
Illustration 4 g00423128
Note: For assembly and installation of Duo-Cone Seals , refer to Disassembly and Assembly, "Duo-Cone Seals - Install".
Use Tooling (G) in order to install the Duo-Cone seal in the flange.Note: The rubber seal and the surface that makes contact with the seal must be clean and dry. After installation of the seal, put clean oil on the contact surface of the metal seal.
Illustration 5 g00423129
Apply Tooling (J) on the contact surface of cage (4) .
Install cage (4) in the steering clutch case.
Install bolts (5) that hold the cage in position. Tighten the bolts to torque of 135 14 N m (100 10 lb ft).
Install the Duo-Cone seal in the cage with tool (B) .
Illustration 6 g00423130
Install flange (6) on the pinion shaft.
Install tooling (H) .
Push the flange into position with a force of 311 - 355 kN (70,000 - 80,000 lb).
Remove tool (H) .
Illustration 7 g00431878
Check the distance at Dimension (D) . Dimension (D) is that distance from the face of the flange to the shoulder on the pinion shaft. Dimension (D) must be 3.18 0.76 mm (0.125 0.030 inch).
Install the gasket, and the nut on the end of the pinion shaft. Tighten the nut to a torque of 475 69 N m (350 51 lb ft).
Install the lock and the small bolt that holds the lock.End By: Install the steering clutches. Refer to Disassembly and Assembly, "Steering Clutch - Remove and Install".