RETAINER AS 1406816 - Caterpillar

Illustration 1 g01643738
Right side viewNote: All the bores must be free of paint. Use 5P-0960 Grease Cartridge in order to coat all the bores for the pins, the stick, the upper frame and the cylinder pin bores.Note: Install the sleeve bearing (1) in the bore so that the part number of the sleeve bearing is facing outward. (1) 228-5621 Sleeve Bearing Quantity ... 2 Inside diameter ... 120.32 0.04 mm (4.737 0.002 inch) Outside diameter ... 140.260 0.013 mm (5.5220 0.0005 inch) Installation depth of the sleeve bearing ... 9.5 0.8 mm (0.37 0.03 inch) (2) 113-2963 Pin As Pin diameter ... 89.850 0.025 mm (3.5374 0.0010 inch) Bore diameter for the pin assembly ... 90.043 0.043 mm (3.5450 0.0017 inch) (3) 192-8321 Pin Pin diameter ... 109.850 0.040 mm (4.3248 0.0016 inch) Bore diameter for the pin ... 110.043 0.043 mm (4.3324 0.0017 inch) (4) Lubricate the sealing lip of two lip type seals lightly with the lubricant that is being sealed. Install the dust seal so that the lip faces outside, as shown. Install two lip type seals so that the lip type seals do not extend beyond the face of the boss. (5) 251-2547 Pin As Pin diameter ... 119.85 0.04 mm (4.718 0.002 inch) Bore diameter for the pin assembly ... 120.043 0.043 mm (4.7261 0.0017 inch) (6) As required, use the following shims in order to adjust the maximum lateral clearance. The steel shim should be located at the boom side: Lateral clearance for Gosselies facility ... 1.0 mm (0.04 inch) Lateral clearance except for Gosselies facility ... 1.6 mm (0.06 inch) 147-3957 Shim Quantity ... 1 Thickness of the shim ... 0.5 mm (0.02 inch) 093-0074 Shim Quantity ... 1 Thickness of the shim ... 1.0 mm (0.04 inch)