RETAINER 1793648 - Caterpillar

Engine ECM
Connect a laptop computer with Cat ® Electronic Technician (Cat ET) to the machine via the communication adapter.
Place a key in the key start switch.
Turn the key to the "ON" position.
Start Electronic Technician and establish communications with the machine.
Select the Engine ECM from the ECM Summary page in Cat ET.
Illustration 1 g06044185
MSS Uninstall
Select "Machine Security System Uninstall" from the Service menu.
Illustration 2 g06085768
Uninstall Screen
Select the "Uninstall" button at the bottom of the page. This button will launch the "Uninstall Confirmation" dialog box.
Illustration 3 g06085772
Uninstall Confirmation
Select "Yes" to continue.
Illustration 4 g06085794
Factory password entry
Enter Factory Password #1 and Factory Password #2. Then, click the "OK" button
Illustration 5 g06085800
Immobilizer status
Click the "OK" button on the Immobilizer Status dialog box.
Illustration 6 g06085804
The engine immobilizer is now uninstalled. Proceed to the following section to complete the uninstall process.Transmission ECM
On older machines, all Immobilizer software must be uninstalled before proceeding with the followings steps.On newer machines, when you uninstall the Machine Security System via the Configuration screen, all the Immobilizer software in other ECM's will be automatically uninstalled.
Select the Transmission ECM from the ECM Summary screen in ET.
Illustration 7 g06044268
MSS Install
Select "Service" from the toolbar on the Cat ET window. This selection will bring up the configuration screen. Select "Machine Security System Install" Do not select the Uninstall option.
Double-click "Advanced Machine Security Installation Status".
Illustration 8 g06044329
Change Parameter Value
Selecting "Advanced Machine Security Installation Status" will launch the Change Parameter Value window.
Click the drop-down and select "Not Installed".
Click "OK".A prompt will appear asking if you are sure that you want to program this parameter? Select "Yes".
Illustration 9 g06085807
MSS Status Verification
Verify that this parameter has uninstalled correctly. Check that the status indicates "Not Installed" in ET. The MSS system should now be fully uninstalled and have no lockout implications.