RETAINER AS 1Q3041 - Caterpillar

Illustration 70 g00275796
View A-A of Illustration 69. (L) Yellow (CKT 429 Terminal 4 ), (M) Purple (CKT 446 Terminal 14) and (N) Black (CKT200).
Connect the opposite end of 135-7089 Harness Assembly (7) as shown in Illustration 69 and Illustration 70.
Connect one end of 135-7090 Harness Assembly (8) to the instrument panel harness connection (H) .
Illustration 71 g00275799
Route the yellow wire of 135-7090 Harness Assembly (8) down to 131-4797 Temperature Sender Assembly that is located on the front axle.
Route the purple wire of 135-7090 Harness Assembly (8) down to 131-4797 Temperature Sender Assembly that is located on the rear axle.Installation Of 143-0001 Oil Cooler Guard Group
Table 12
143-0001 Oil Cooler Guard Group    
Item     Part Number     Description     Quantity    
1     7Y-5227     Bolt     6    
2     8T-0282     Bolt     6    
3     6V-3668     Bolt     12    
4     5P-8247     Washer     12    
5     143-0004     Plate Assembly     2    
6     143-0003     Plate Assembly     2    
7     143-0002     Plate     2    
Illustration 72 g00275801
Install one 143-0004 Plate Assembly (5) on the right side of the rear axle using three 7Y-5227 Bolts (1) and existing washers.
Install one 143-0003 Plate Assembly (6) on the left side of the rear axle using three 8T-0282 Bolts (2) and existing washers.
Install 143-0002 Plate (7) onto 143-0004 Plate Assembly (5) and 143-0003 Plate Assembly (6) using six 6V-3668 Bolts (3) and 5P-8247 Hard Washers (4) .
Illustration 73 g00275802
Install one 143-0004 Plate Assembly (5) on the right side of the front axle using three 7Y-5227 Bolts (1) and existing washers.
Install one 143-0003 Plate Assembly (6) on the left side of the front axle using three 8T-0282 Bolts (2) and existing washers.
Install 143-0002 Plate (7) onto 143-0004 Plate Assembly (5) and 143-0003 Plate Assembly (6) using six 6V-3668 Bolts (3) and 5P-8247 Hard Washers (4) .Completion Of The Installation
After installing the Brake Oil Cooler System, perform the following steps in order to complete the installation.
Fill the front axle oil and the rear axle oil to approximately 60% of the capacity.
Fill the hydraulic tank to the correct level.
Install the rear mounted counterweights.
Install the wheels on the rear axle.
Install the radiator grill.Note: Use the appropriate lifting devices and service tools to install the radiator grill.
Paint the surfaces that are affected by the installation procedure.
Move the machine off the jack stands.
Use the appropriate service tools to make the machine operable after the installation.