RETAINER 2S4364 - Caterpillar

Configuration Parameters
Configuration parameters concern various engine features. Some parameters can affect the performance of the engine. Most of the parameters may be programmed with an Electronic Technician (ET) service tool. Some of the parameters require a password in order to be programmed.Note: For information on programming the parameters, use the appropriate ET service tool and see the Service Manual, "Troubleshooting" module.Some parameters may not be available on all applications. If a parameter is not available the ET service tool will indicate that the parameter is “unavailable” when the parameter is selected. Table 1 is a list of typical configuration parameters.
Table 1
Typical Configuration Parameters
Parameter Programmability
"Air shutoff" Yes
CAT "Datalink #2 identifier" Yes
"Crank duration" Yes
"Crank terminate speed" Yes
"Cold cylinder cutout" Yes
"Cooldown speed" Yes
ECM serial number No
"Engine acceleration rate" Yes
"Engine cooldown duration" Yes
"Engine cooling system"(1) Yes
"Engine prelube duration" Yes
"Engine rated speed" Software dependent
"Engine rotation" Software dependent
"Engine serial number" Yes
Equipment ID Yes
"Ether control" Yes
Fuel correction factor Yes
"Fuel ratio control" Yes
"Low idle" Yes
"Maximum number of crank cycles" Yes
"Personality Module Part Number" Software dependent
"Personality module release date" Software dependent
"Rated fuel position" Yes
"Total fuel" Yes
"Total hours" Yes
"Total tattletale" No
(1) Jacket water aftercooling or separate circuit aftercoolingThe follow