RETAINER-CLA 3256184 - Caterpillar

The Camera Screen is Malfunctioning
If the camera screen is malfunctioning, refer to one of the following screen symptom.Possible causes for the camera displays a blue screen
Incorrect camera hardware/software.
Failed camera.
Incorrect display software.
Display failure.Possible causes for the camera displays a black screen
Failed switch from 4 camera view when enabling surround view
Camera manager crashesTroubleshooting Steps
If blue screen is in place of the camera image, proceed to Table 4.
If black screen is in place of the camera image, proceed to Table 5.
Table 4
The Camera Displays a Blue Screen
Troubleshooting Test Steps Values Results
1. Verify that correct display software is flashed
A. Verify that the correct display software is flashed.
OK -.
Proceed to Test Step 2.
NOT OK -
Flash correct software. After flashing the software, wait two minutes. Then turn the push to start ring to the off position and the disconnect switch to the off position. Then turn the disconnect switch to the on position, and the push to start ring to the on position. Check the camera view.
2. Power cycle
A. Cycle push to start switch on and off.
B. Push in start switch to start machine.
The symptom