RETAINER-SEAL 3565974 - Caterpillar

Governor Control Group
1.Control lever. 2.Cable end. 3.Friction disc (behind plate). 4.Locknut. 5.Locknut. 6.Governor lever. 7.Cable end. A.Angle (governor at high idle). B.Angle (governor at low idle). C.Angle (engine off).(3) Friction disc (behind plate). Put new disc in kerosene for 24 hours before installation. Tighten nut only enough so control lever (1) does not slip when the engine is at high idle.(4) Torque for locknut ... 8 5 N m (6 2 lb. ft.)(5) Torque for locknut ... 38 2 N m (28 1 lb. ft.)(A) Angle (approximately) ... 57°(B) Angle (approximately) ... 34°(C) Angle (approximately) ... 3°Cable Adjustment Procedure
1. Put governor lever (6) in SHUTOFF position.2. Adjust cable ends (2) and (7) so control lever (1) is also in SHUTOFF position [approximately 5 mm (.2 in.) from end of slot].