RETAINER-G.E.T. 3G9549 - Caterpillar

Installation Procedure
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01198864
Attach Tooling (D) and a suitable lifting device to transmission planetary (3). The weight of transmission planetary is approximately 953 kg (2100 lb).
Position transmission planetary (3) into transmission housing (1). Install bolts (2).
Illustration 2 g01197182
Attach Tooling (A), Tooling (B), Tooling (C) and a suitable lifting device to transmission housing (1). The weight of transmission housing (3) is approximately 1270 kg (2800 lb). Position transmission housing (1), as shown. End By:
Install the transmission hydraulic control valve. Refer to Disassembly and Assembly, "Transmission Hydraulic Control - Install".
Connect the transmission and the torque converter. Refer to Disassembly and Assembly, "Transmission and Torque Converter - Connect".