RETAINER 6E5887 - Caterpillar

Illustration 64 g01886833
Illustration 65 g01886826
Install bearings (24) and (26) in gear (25).
Position thrust discs (23) and (27) on each side of gear (25).
Put gears (25) in position in the carrier. Install planetary shafts (21). Make sure that the holes in planetary shafts (21) are in alignment with the holes in the carrier. Install spring pin (22). Make sure that spring pins (22) are flush with the counterbore in the carrier.
Repeat Steps 79 through 81 for the installation of the remaining gears.
Illustration 66 g01886819
Put slinger (20) in position in the carrier. Install locks (18) and bolts (19) that hold the slinger (20) in position. Bend the tabs on locks (18).
Illustration 67 g01886818
Put carrier assembly (17) in position on the shaft assembly. Install the spacer on the carrier. Use Tooling (E) to install retaining ring (16) on the shaft assembly.
Illustration 68 g01886816
Install gear (15) on the manifold assembly.
Illustration 69 g01886815
Install dowels (14) in the manifold assembly.
Start with a friction disc and install friction discs (12) and clutch plates (13).
Illustration 70 g01886814
Install seals (10) on the piston. Apply clean transmission oil to seals (10).
Install piston (11) in clutch housing (9).
Illustration 71 g03701867
Illustration 72 g01886812
Install springs (8). Use Tooling (D) to hold the piston in the housing. Attach Tooling (B) and a suitable lifting device to the housing. The weight of clutch housing (9) is approximately 32 kg (70 lb).
Install clutch housing (9). Install bolts (7) that secure the planetary group. Tighten bolts (7) to a torque of 115 7 N m (85 5 lb ft)
Illustration 73 g03704199
Attach Tooling (B) and a suitable lifting device to planetary group (6). The weight of planetary group (6) is approximately 565 kg (1250 lb). Install planetary group (6) into transmission case (5).
Illustration 74 g01915279
Install tubes (4) and the O-ring seals.
Illustration 75 g01915255
Install Tooling (B) and a suitable lifting device to modulating valve assembly (2). The weight of modulating valve assembly (2) is approximately 43 kg (95 lb).
Install bolts (3).
Illustration 76 g01915234
Connect tube assembly (1).
Illustration 77 g01915213
Remove the transmission assembly from Tooling (A). End By:
Connect the transmission and the output transfer gears.