RETAINER 7T3126 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 137-4370 Load Leveler 1
B 138-7576 Link Bracket 4
C 5P-3931 Anti-Seize Compound 1 Note: Make sure that the mating surfaces of the rear axle assembly and of the rear loader frame are clean prior to the installation of the rear axle assembly.
Illustration 1 g02653779
Illustration 2 g02709253
Position rear oscillating axle (12) under the rear main frame, as shown.
Attach Tooling (B) to both ends of rear oscillating axle (12).
Attach Tooling (A) and a suitable lifting device to Tooling (B). The weight of rear oscillating axle (12) is approximately 6830 kg (15050 lb).
Illustration 3 g02709256
Illustration 4 g02709257
Apply Tooling (C) to dowels (17) and (18).
Raise rear oscillating axle (12). Make sure that dowels (17) and (18) are aligned with the holes in the rear main frame.
Illustration 5 g02709255
Install bolts (15) that secure rear trunnion support (16) to the rear main frame. Tighten bolts (15) to a torque of 1150 150 N m (850 110 lb ft).
Illustration 6 g02709254
Install bolts (14) that secure front trunnion support (13) to the rear main frame. Tighten bolts (14) to a torque of 1150 150 N m (850 110 lb ft).
Illustration 7 g02709253
Place a suitable block between rear oscillating axle (12) and the rear main frame on both sides of the machine. This will keep rear oscillating axle (12) from oscillating during the installation procedure.
Remove the suitable lifting device and Tooling (B).
Illustration 8 g02709252
Install panel assemblies (11).
Illustration 9 g02709250
Connect tube assembly (9) to the rear trunnion support. If necessary, install tube assembly (10).
Illustration 10 g02709249
Install the O-ring seal and temperature sensor (7). Tighten temperature sensor (7) to a torque of 20 5 N m (177 44 lb in)
Connect harness assembly (5) to temperature sensor (7).
Connect hose assembly (8) to the rear oscillating axle.
Illustration 11 g01445785
Connect tube assembly (6).
Connect clips (4) that secure harness assembly (5) to the rear oscillating axle.
Connect hose assembly (3), hose assembly (2), and hose assembly (1).
Fill the rear oscillating axle housing and the final drive assemblies with oil. Refer to the Operation and Maintenance Manual, "Differential and Final Drive Oil - Change".
Purge the air from the rear service brakes. Refer to Testing and Adjusting, "Brake System Air - Purge".
Check the oil level of the hydraulic tank for the steering system and for the braking system. Refer to the Operation and Maintenance Manual, "Hydraulic System Oil Level (Steering and Brake) - Check". End By:
Install the rear tires and the rims.
Install the rear drive shaft.
Install the crankcase guard.