RETAINER 8A5896 - Caterpillar

Assembly Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Dirt and contaminants can damage precision components that are in pumps and motors. All disassembly and assembly procedures must be performed on a clean work surface. Clean all the interior components in clean solvent. Dry all the interior components with compressed air. Plug ports and plug hoses on the machine during repair.
Illustration 1 g01004799
Install stator cover (4) to stator (3) .
Install screws (17) to stator cover (4) .
Install ring (16) to stator (3) .
Illustration 2 g01004792
Install rings (14) and rings (15) to housing (2) .
Illustration 3 g01004787
Install housing (2) to stator (3).
Illustration 4 g01004781
Install cover (13) to housing (2) .
Install screws (12) to cover (13).
Install ring (11) to housing (2) .
Illustration 5 g01004776
Install O-ring seals (10) and rings (11) to rotor cover (1) .
Illustration 6 g01004759
Install setscrew (8) and nut (9) to rotor cover (1) .
Install rotor (1) to housing (2) .
Install seal (7) to rotor cover (1) .
Install cover (6) to rotor cover (1) .
Install bolts (5) to cover (6) .End By: Install the swivel. Refer to Disassembly and Assembly, "Swivel - Install ".