RETAINER-SPRING 8E5727 - Caterpillar

Illustration 13 g01173867
Install washer (27) and retaining ring (26) in stator (25) . Repeat this step for the other side of stator (25) .
Illustration 14 g01173866
Install stator (25) on impeller (21) .
Install spacer (24) and retaining ring (22) over carrier shaft (23) .
Illustration 15 g01173864
Install impeller (21) and bolts (20) . Tighten bolts (20) to a torque of 60 7 N m (44 5 lb ft).
Illustration 16 g03835392
Install bearing (19) on output shaft (17) .
Install seal ring (18) .
Illustration 17 g01173862
Install output shaft (17) and retaining ring (16) .
Illustration 18 g01173861
Install drive gear (15) .
Illustration 19 g01174016
Use Tooling (A) and a suitable lifting device to install the torque converter housing over the torque converter assembly. The weight of the torque converter housing is approximately 113 kg (250 lb).
Install bolts (7) . Tighten bolts (7) to a torque of 60 7 N m (44 5 lb ft).
Illustration 20 g03835382
Install bearing (14) and drive gear shaft (12) in pump drive gear (13) .
Use Tooling (B) to install pump drive gear (13) into the housing.
Illustration 21 g01173853
Install bolt (11) on drive gear shaft (12) . Tighten bolt (11) to a torque of 105 20 N m (77 15 lb ft).
Illustration 22 g03835375
Install pump drive flange (10) and bolts (9) . Tighten bolts (9) to a torque of 60 7 N m (44 5 lb ft).
Illustration 23 g01173847
Install torque converter speed sensor (8) . Adjust torque converter speed sensor (8) in order to maintain an air gap of 0.71 0.18 mm (0.028 0.007 inch). Tighten torque converter speed sensor (8) to a torque of 25 5 N m (18 4 lb ft).
Illustration 24 g01174020
Install washer (6) and bolt (5) . Tighten bolt (5 ) to a torque of 105 20 N m (77 15 lb ft).
Illustration 25 g01173844
Illustration 26 g01173843
Install torque converter inlet relief valve (4) and the O-ring seal.
Install transmission hydraulic control relief valve (3) and bolts (2) to torque converter housing (1) .End By: Connect the torque converter to the transmission and to the output transfer gears. Refer to Disassembly and Assembly, "Torque Converter to Transmission , Output Transfer Gears - Connect".