RETAINER 9P3473 - Caterpillar

Removal Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Turn the battery disconnect switch to the OFF position. Refer to Operation and Maintenance Manual, "Battery Disconnect Switch".
Illustration 1 g01442666
Remove upper grill (1) .
Illustration 2 g01442667
Remove bolts (2). Position lower grill (3) to the side.
Illustration 3 g01442684
Remove shields (4) .
Illustration 4 g01453593
Note the location of bolts on guard (5) for installation. Remove guard (5). Remove belt (6). Refer to Operation and Maintenance Manual, " Belt - Inspect/Adjust/Replace".Note: Spacers (not shown) are located behind the bolts that hold the cover in place.
Illustration 5 g01453596
Disconnect harness assemblies (8). Remove alternator (7) .Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 6 g01453596
Install alternator (7). Connect harness assemblies (8).
Illustration 7 g01453593
Install belt (6). Refer to Operation and Maintenance Manual, " Belt - Inspect/Adjust/Replace". Install guard (5) .
Illustration 8 g01442684
Install shields (4) .
Illustration 9 g01442667
Position lower grill (3). Install bolts (2).
Illustration 10 g01442666
Install upper grill (1) .
Turn the power disconnect switch to the ON position.