RHEOSTAT 3N5981 - Caterpillar

ECM Serial Number
Used to read the electronic control module serial number.Software Group Part Number
Used to read the software group part number.Software Group Release Date
Used to read the software release date in month and year format.Software Group Description
Used to read the software group description.Monitoring System Display
Illustration 23 g06259916Service Mode Enable Code
Used to read and program the code/password to enable the service mode for the monitoring system.Display Language Status
Table 1
Supported Languages
English Spanish French Portuguese
German Norwegian Swedish Finnish
Dutch Danish Italian Greek
Turkish Indonesian Russian Japanese
Hungarian Icelandic Arabic Traditional Chinese
Czech Polish Simplified Chinese Thai
Slovenian Slovakian Estonian Latvian
Lithuanian Malaysian Korean Portuguese (Brazil)
Farsi Hebrew Serbian Croatian
Bulgarian Romanian Vietnamese Mongolian
Macedonian Burmese Khmer Ukrainian Used to read and program the status of the monitoring system display language for the selected operator within the Operator Data Transfer protocol. Languages supported are included in the table. Not all languages may be applicable to every machine.Information Units Status
Used to read and program the selected display units on the monitoring system. The status for the units can be either "English Units" or "Metric Units".Backlight Percent
Used to read and program the monitoring systems display backlight percent for the selected operator within the Operator Data Transfer protocol. Valid data range is 0 to 100%.Object Detection Definitions
ECM Identification Parameters
Illustration 24 g06260009Product ID
Used the read and program the product identification number i.e. the Caterpillar serial number.ECM Part Number
Used to read the part number of the control module hardware.ECM Serial Number
Used to read the electronic control module serial number.Software Group Part Number
Used to read the software group part number.Software Group Release Date
Used to read the software release date in month and year format.Software Group Description
Used to read the software group description.Camera System
Illustration 25 g06260011Camera #1 Location
Used to read and program the location on the machine where camera #1 is installed. This indicates the location of the camera on the machine and not the view covered by the camera. Valid location configurations are "Ripper", "Left", "Right", "Front", "Rear", and "Not Installed".Camera #2 Location
Used to read and program the location on the machine where camera #2 is installed. This indicates the location of the camera on the machine and not the view covered by the camera. Valid location configurations are "Ripper", "Left", "Right", "Front", "Rear", and "Not Installed".Automatic Camera View Dimming Enable Status
Used to read and program whether the automatic camera view dimming feature is enabled. Camera view will automatically dim once application reaches a certain state for example machine driving above certain ground speed, the dimming helps reducing distractions to operator. Status is either "Enabled" or "Disabled".Radar System
Illustration 26 g06260014Object Detection Alarm Mode
Used to read and program the alarm mode that sounds when an object is detected near the machine.In "Continuous" mode, anytime the system detects an object, an audible alarm will sound, starting with a frequent alarm at some distance away then will progressively shorten in period as the object travels closer to the sensor, and will end with a constant tone when an object is sufficiently close.In "Discrete" mode, two beeps indicate that an object has only entered the